Industrial LPG Gas Saver

The magnets are embedded in a body of non-magnetic material, such as brass, copper and stainless steel to secure they  to the fuel line. No cutting of the fuel line and 1) no hose and clamps are necessary 2) cutting hose pipe with clamp to install this device, outside a fuel line without disconnection or modification of the fuel or ignition system for producing magnetic flux in the flow path of combustible fuel within the pipe. These units have been installed without other fuel line or ignition adjustments to treat appliances failing required emission tests as an inexpensive retrofit accessory to give substantially immediate improvements of up to the order of 80 % reduction in hydrocarbon and carbon monoxide emissions.

Result :

Dust in exhaust gas from a boiler was measured by both weight and concentrate methods. It was found that at the same weight of dust contained in exhaust gas, the exhaust gas generated after the magnetizing treatment according to these devices exhibited in higher value in concentration than that generated without magnetization. This fact that dust particles after magnetization are finer than those usually found, which in turn, means that oil particles are made finer by the magnetizing treatment of these devices.

    In boilers the combustion conditions are improved by applying magnetism to fuel according to these devices.

    - The flame becomes brighter and turns from red to white orange. A high temperature bright flame is observed.
    - The flame is reduced in vertical length and extended laterally.  The rates of combustion becomes higher.
    - Spark in the flame is reduced or eliminated.
    - Vibrating combustion is prevented.
    - Pollution material content in exhaust gas is reduced.